Rifle Scope Ring
Featured Rifle Scope Ring For Sale:
![]() 1 Warne QD Rifle Scope Rings Med US $49.99
|
![]() American Rifle 30mm low scope rings 823 height US $154.99
|
![]() American Rifle one inch low scope rings 823 height US $154.99
|
![]() American Rifle 35mm high scope rings 122 height US $154.99
|
i'm have to adjust the windage on my rifle scope all the way up^ and it's still not up high enough..?
well i brought a new scope it's a bsa 7x20 .22 rifle scope.
i have a weaver scope mount base and weaver scope rings too.
altogether i probably got like 80$ just in the scope set-up and now that i have it mounted and ready to go the scope's windage is set for up^^ as far as it can go and my rifle is still not on target it is close though.
thanxx-bo
sorry. i meant elevation!
If it has been properly mounted using the correct mount and rings, you will need to have the scope checked out to be sure that there isn't something wrong with it. If everything is okay, you will have to shim up the scope. Since you are adjusting your scope "UP", I naturally assume it is shooting too low. Run your elevation adjustment back to the neutral position and loosen both rings. Put a piece of shimstock under the scope in the rear ring. You can buy brass shim stock from some machine shops. Just cut a piece and put it in the bottom of the rear ring between the ring and the scope. This will raise up the rear of the scope a few thousandths and may get you on target. If I misunderstood and you are shooting too high, you will want to shim up the front ring rather than the rear ring. You may have to add more than one piece of shim to the ring if one is not enough. If you can't find brass shimstock, you can substitute a piece of aluminum cut from the side of a drink can.
























































































